A chick out of the shell

A chick out of the shell

This model is obtained by using two colors of the PLA consumables from the buddy printer. Print the model of the indoor temperature is 28 ℃.

 

Download: A chick out of the shell. STL

The section is Cura software. The detailed setting parameters are as follows:

1. To make the model print better, we should check Buddy for the following:

Belt is tight enough---screw is tight enough---the wire connection is correct---x/y/z axis movement is correct---auto home works fine--- temperature works fine---preheat works fine.

To celebrate the arrival of Christmas, print some of your favorite models to decorate.

 

2. Slicing setting

Print the PLA slice Settings with buddy color Double color printing: brush into buddy double color firmware: Athorbot buddy dual v1.0. Hex.

Save to Gcode file and copy to the SD card.

Setting the Mix_Percent at 0 or 100 during printing.

3. The printing process

4. Result

 



Leave a comment